Manual 05 - Headphone Jack / Earpiece Speaker

Before disassembly, thoroughly wash and dry your hands.

Remove the stylus, battery cover and battery. Place in ZONE I.

Remove SIM card and SD card. Place in COMPARTMENT A.

Remove twelve 4.0 mm #00 Phillips screws. Place in SLOT 1.

Insert the pointed end of the spudger into the stylus slot (Picture 1). Lift up to create enough space to grab the mid-frame, as in Picture 2.

Use your fingers to gently peel up mid-frame.

Place mid-frame in ZONE II.

Use the Blue Pry Tool to disconnect six ribbon cable connectors on the logic board.

Disconnect the antenna cable using the blue pry tool as shown in Picture 2.

Use your fingers to brush away ribbon cables while gently lifting away the logic board from bottom to top. Place in ZONE III.

Remove 3.0 mm Phillips screw from headset jack assembly. Place screw in SLOT 2.

The earpiece speaker and headset jack are one assembly, shown in Picture 3:

Use the pointed end of the spudger to gently pry up the headset jack.

Loosen the headset jack, but don't pull the assembly free just yet.

Wedge the spudger under the earpiece speaker. Then gently peel up the assembly with your fingers until its free.

Place the headset jack and earpiece speaker assembly in COMPARTMENT D.

Replace headset jack and earpiece speaker assembly from COMPARTMENT D.

Replace 3.0 mm screw from SLOT 2.

Replace the logic board from ZONE III. Make sure no cables are trapped underneath the logic board.

Reseat six cables.

Reseat antenna.

Replace mid-frame from ZONE II. Note the clips at the top of the mid-frame.

Place the mid-frame clips in their slots at the top of the front panel before seating the rest of the mid-frame.

Replace twelve 4.0 mm Phillips screws from SLOT 1.

Replace the SD card & SIM card from COMPARTMENT A.

Replace the battery cover, battery and stylus from ZONE I.